To separate completely a pair of units linked for stereo operation would take a few minutes of cable plugging and unplugging each time you wanted to do it - there is no single switch you can throw to perform this action. Have you tried programming each unit to be mono even though the stereo linking is in place? It depends on what you mean by "easily", and also how you are using the two units. PapaG, post: 459883, member: 51484 wrote: Is it possible to set up two Liquid Channel units for stereo operation and easily switch back to using them as two mono channels? Connect the recorder/interface clock input between the two LC units using the T-piece with no terminator on the recorder/interface. If you can, I would set up the master LC as the master clock driving both the slave LC and your interface or recorder as a daisy-chain via a 75 Ohm T-piece. See the diagram example 5 on p12 of the =" Channel User Guide.Īssuming you have a recorder or an interface that can accept an AES/EBU stereo input, you must be careful about the clocking, and may need to run another BNC clock cable from the recorder or interface to the master LC. Your stereo digital output is available on the AES/EBU connector on the master box. You will also need a 75 Ohm BNC cable connecting the clock out of the master box to the clock in on the slave box. Use the setup application to select the two channels as your sources for the stereo output. Yes, for linking a pair of Focusrite Liquid Channels, cross-connect the Digital Link RCA inputs and outputs on the two boxes using RCA cables specified for digital use (e.g.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |